RobbMc Performance Products - Chevrolet Mini-Starter

Compare RobbMc Starters with other starters	PN 2000 $239.00
PN 2025 Pinion Support Modification.......$50 Prevents pinion gear deflection on hard to start engines. Deflection can damage the pinion gear, the flywheel ring gear, and even the starter gear reduction assembly. Recommended for engines with any of the following: Over 500 cubic inches Over 11.5 to 1 compression ratio Crank trigger ignitions Magneto ignitions More than 18° of ignition advance during cranking Locked out or no distributor advance Electronic start retard
PN 2008 Replacement Gear......................$20 Includes new retaining ring.
PN 2009 Short Gear..................................$10 This gear is 1/8" (.125") shorter than the standard length gear and is used when the standard gear is too close to the ring gear on the flywheel. Includes new retaining ring.
PN 2011 Replacement Nose......................$49 New screws included.
PN 2020 Replacement Solenoid................$20
This starter fits: Chevy small block and big block V8 with 153 or 168 tooth flywheels/flexplates. (will not fit early engines with bellhousing mount starters or engines which are only drilled and tapped for offset mounting bolts) Chevy 3.3/3.8/4.3L V6 Notes: This starter is 7-7/16" long from the center of the mounting bolts to the end of the motor. The solenoid can be rotated to any position without taking the starter apart. We recommend positioning the solenoid under the starter motor and towards the oil pan. This makes it easier to connect the battery cable and keeps the solenoid away from exhaust heat. This starter uses standard OEM length mounting bolts available at any auto parts store. Use only true starter bolts, which have knurls on the shank. Ministarter Installation Instructions and Troubleshooting Guide Note: Microsoft Word is required to view/print this document. Top of Page Back to Products Page
© 2007 ROBBMC PERFORMANCE PRODUCTS. ALL RIGHTS RESERVED.