RobbMc Performance Products are proudly made in the USA
Ford M/T Mini-Starter
Ford M/T Mini Starter

Compare RobbMc Starters with other starters

 PN 2003

$259.00
PN 2025    Pinion Support Cone Modification.......$40
Prevents pinion gear deflection on hard to start engines. Deflection can damage the pinion gear, the flywheel ring gear, and even the starter gear reduction assembly. Recommended for engines with any of the following:
  • Over 500 cubic inches
  • Over 11.5 to 1 compression ratio
  • Crank trigger ignitions
  • Magneto ignitions
  • More than 18° of ignition advance during cranking
  • Locked out or no distributor advance
  • Electronic start retard



PN 2008    Replacement Gear......................$30
Includes new retaining ring.
PN 2014    Replacement Nose.....................$49
Also known as the mounting plate.
PN 2020    Replacement Solenoid................$20

This starter fits:
  • Most *  200/240/250/300 Straight 6 with 3 or 4 speed manual trans.
  • Most *  255/289/302/351W/351C with 3 or 4 speed manual trans.

* Some applications will use RobbMc starter 2001. See notes below to determine correct register diameter and gear protrusion.

Notes:
  • This starter has a register diameter of 4.133" and the gear protrudes .25" past the mounting surface with the starter at rest.
  • This starter is 8-1/16" long from the mounting surface to the end of the motor.
  • The solenoid can be rotated to any position without taking the starter apart. We recommend positioning the solenoid under the starter motor and towards the oil pan. This makes it easier to connect the battery cable and keeps the solenoid away from exhaust heat.
  • This starter has three mounting holes. Some applications will only use two of the three holes. The "ear" for the unused hole can be cut off if desired.





Top of Page            Back to Products Page

© 2010 ROBBMC PERFORMANCE PRODUCTS. ALL RIGHTS RESERVED.